Floyd County area

Floyd County, Texas covers 992.5 square miles: 992.1 square miles of land and 0.38 square miles of water. Its county seat is Floydada. An estimated 4,881 people lived there in 2025.

Official Census measurements · GEOID 481532026 Gazetteer · retrieved September 27, 2026
Land area992.1 mi²
Water area0.38 mi²
Population (2025)4,881
People per mi²4.9

County outline

Generalized outline of Floyd County, Texas
2025 Census cartographic boundary, fitted to this frame. County maps are not at a common scale. The 2026 area measurements below come from the separate Gazetteer release. Map source and limitations.

Where Floyd County is located

Floyd County highlighted on a map of all U.S. county equivalents. About the maps

Area breakdown

Land accounts for 100% of Floyd County’s measured area and water for 0%. Its combined area converts to 2,570.6 square kilometers or approximately 635,215 acres.

Green: land · blue: water

MeasurementSquare milesSquare kilometersAcres
Land992.1432,569.639634,971.5
Water0.380.984243.2
Total992.5232,570.623635,214.7

How Floyd County compares

By original Census land area, Floyd County ranks #76 of 254 in Texas and #692 of 3,222 nationally. National rankings include the 50 states, District of Columbia, and Puerto Rico.

Its land area is 1.092 times the Texas county-equivalent median of 908.7 square miles. It accounts for 0.4% of the combined county land area in the state.

See the complete Texas ranking · What counts as a county equivalent?

Population and density of Floyd County

The Census Bureau estimates that 4,881 people lived in Floyd County on July 1, 2025. That ranks #2,898 of 3,222 county equivalents nationally and #200 of 254 in Texas. Since the April 1, 2020 estimates base of 5,397, the population has declined by 516 (−9.6%), compared with +8.8% for Texas as a whole.

With 992.1 square miles of land, that is 4.9 people per square mile (1.9 per km²), placing Floyd County #2,857 nationally for density and #199 in Texas. The median county equivalent has 47 people per square mile; the Texas median is 22. Put another way, there are about 130 acres of land per resident.

Estimated population, 2020–2025 · line scaled to this county’s own range
July 1202020212022202320242025
Estimate5,3695,2935,2465,1245,0204,881
Change—−76−47−122−104−139

U.S. Census Bureau, Vintage 2025 population estimates. Estimates are revised each year and are not decennial census counts. Density divides the whole population by the whole county’s land area, so it describes an average, not how settlement is distributed within the county. Population sources and methods.

Cities and towns in Floyd County

2 incorporated places lie at least partly in Floyd County. Together they are home to 3,760 people (77%); the other 1,121 (23%) live outside any incorporated place, in unincorporated communities and rural areas.

The largest is Floydada city, with 2,420 residents in the county.

Incorporated placePopulation 2025Since 2020Land mi²
Floydada cityCounty seat2,420−9.5%2.033
Lockney town1,340−10.2%1.548

Population: U.S. Census Bureau Vintage 2025 subcounty estimates, counting only the part of each place inside Floyd County. Land: 2026 Census Gazetteer, for the whole place even where it extends into other counties. How communities are listed.

Metropolitan area

Floyd County is an outlying county of the Plainview, TX Micropolitan Statistical Area. Its 2 county equivalents have 36,700 residents on 1,996.8 square miles of land; Floyd County accounts for 49.7% of the land and 13.3% of the residents. By combined land it ranks #79 of 542 micropolitan areas, and #370 by population. It belongs to the Lubbock-Plainview, TX Combined Statistical Area.

County equivalentPopulation 2025Land mi²
Hale County31,8191,004.7
Floyd County4,881992.1

ZIP codes

7 ZIP Code Tabulation Areas have land in Floyd County; 4 of them have most of their land inside the county, and the others mainly cover neighboring areas.

79231792347923579241792507925579258

ZIP Code Tabulation Areas are the Census Bureau’s approximations of USPS ZIP Code service areas, from the 2020 Census relationship files. Lighter codes have less than half of their land in this county. Post-office-box and single-address ZIP Codes have no tabulation area.

Counties bordering Floyd County

Floyd County shares a land border with 5 county equivalents. It has more land than 4 of them. The largest neighbor is Hale County (1,004.7 mi²) and the smallest is Swisher County (890.2 mi²). Together with its neighbors, Floyd County forms a block of 5,676.7 mi² of land, of which it holds 17.5%.

Map of Floyd County and the 5 county equivalents that border it Hale County, Texas: 1,004.7 mi² landMotley County, Texas: 989.6 mi² landCrosby County, Texas: 900.2 mi² landBriscoe County, Texas: 900 mi² landSwisher County, Texas: 890.2 mi² land
Floyd County (dark) and its bordering county equivalents. Select a neighbor to open its profile. Drawn from the 2025 Census cartographic boundaries in an equal-area projection. How borders are determined.
Bordering county equivalentLand mi²Size vs. FloydCompare
Hale County1,004.7about the sameCompare
Motley County989.6about the sameCompare
Crosby County900.21.1× smallerCompare
Briscoe County9001.1× smallerCompare
Swisher County890.21.1× smallerCompare

How big is Floyd County compared with U.S. states?

Floyd County has less land than any of the 50 states. Rhode Island, the smallest state by land area, has 1,033.9 mi², about 1 times as much. Texas’s county land could hold about 263 areas the size of Floyd County.

Land area: Floyd County and the closest-sized states
Floyd County992.1 mi²
Rhode Island1,033.9 mi²

Another way to picture it: the same land area would fill a square about 31.5 miles (50.7 km) on each side. Real county shapes are rarely square, so this is a scale reference rather than a width or driving distance.

State figures are the sums of each state’s county-equivalent land measurements in the same Census release, so states and counties are compared on the same basis. Published state totals can differ slightly because of rounding. Compare all states · Counties bigger than entire states.

What stands out about Floyd County?

Floyd County has more land than 2,530 of the other 3,221 county equivalents in the dataset.

Land area compared with the typical county equivalent
Floyd County992.1 mi²
Texas median908.7 mi²
National median604.5 mi²

A median is the middle county-equivalent measurement, not the average of the largest and smallest. All three bars use the same linear scale. Very small areas may appear as a thin sliver; the labels retain their values.

Does including water change its rank?

Using land plus water places Floyd County at #785 nationally by total area, 93 places farther from the top than its land rank. Other county equivalents gain more area when their water measurements are included.

Its water share is 0%, compared with a national county-equivalent median of 1.2% — 1.1 percentage points lower. This describes the statistical geography’s land/water mix, not flood exposure or developable land.

Closest positions in the national land ranking

These entries sit immediately beside Floyd County in the national ranking. They can be in different states and are not necessarily geographic neighbors.

Land rankCounty equivalentLand mi²Comparison
#691Logan County, North Dakota992.6Compare
#692Floyd County, Texas992.1This county
#693Arkansas County, Arkansas992.1Compare

Calculated from the same Census release as the area table. Total-area order uses original ALAND + AWATER; water shares and chart labels use published square miles. Calculation details.

Representative coordinates

The Census internal point is 34.073730, -101.303274. It represents a location inside the geography; it is not necessarily the centroid or the address of a courthouse.

Source and precision

U.S. Census Bureau, 2026 Gazetteer Files, Counties. Original ALAND: 2,569,637,274 m²; AWATER: 983,737 m². Rankings use ALAND; exact ties use ascending GEOID. Tables preserve Census-published square miles to three decimals, with conversions based on those values.

Download the official county source ZIP ↗ · Methodology

Common questions

How big is Floyd County?

Floyd County, Texas has 992.1 square miles (2,569.6 km²) of land and 0.38 square miles of water, for a total area of 992.5 square miles. It ranks #692 of 3,222 U.S. county equivalents by land area.

Is Floyd County the largest county in Texas?

No. Floyd County ranks #76 of 254 in Texas by land area. The largest is Brewster County, with 6,183.8 square miles of land.

What counties border Floyd County?

Floyd County shares a land border with Hale County, Motley County, Crosby County, Briscoe County, and Swisher County.

What is the population of Floyd County?

The Census Bureau estimates Floyd County had 4,881 residents on July 1, 2025, ranking #2,898 of 3,222 county equivalents. That is 4.9 people per square mile of land.

What is the county seat of Floyd County?

The county seat of Floyd County is Floydada.

What cities and towns are in Floyd County?

Floyd County has 2 incorporated places. The most populous are Floydada city and Lockney town; 1,121 residents live outside any incorporated place.

Is Floyd County part of a metropolitan area?

Yes. It is an outlying county of the Plainview, TX Micropolitan Statistical Area, which has 2 county equivalents and 36,700 residents.

How many ZIP codes are in Floyd County?

7 ZIP Code Tabulation Areas have land in Floyd County, and 4 of them have most of their land inside the county. Census ZIP Code Tabulation Areas approximate USPS ZIP Code areas.

How does Floyd County compare with U.S. states?

It has less land than every state. Rhode Island, the smallest, has 1 times as much land.

How many acres of land are in Floyd County?

The land measurement converts to approximately 634,972 acres. Including water, total area is approximately 635,215 acres. One square mile equals 640 acres.

Why might another source show a different area?

Check whether it reports land or total area, its Census vintage, and its rounding. Our guide explains how to reconcile county area figures.

Can this establish a property boundary?

No. Statistical measurements and generalized maps do not establish property lines. Consult the relevant local surveying or land-records authority.

Cite this county

Download the complete CSV or JSON dataset